Jump to content
Nugget Shooter Forums
Sign in to follow this  
Riosman

GPZ 7000 ground Balance

Recommended Posts

 

Hello all,

I don't like to execute line 4 every time the GPZ 7000 needs to be ground balanced, is this necessary? I have not been doing it. Bad or good?

Ground Balance with the Ferrite

  1. Find an open area free from targets and place the ferrite on the soil surface.
  2. Turn GPZ 7000 ON.
  3. Select Quick Start on the Detect page.
  4. Select Reset Audio and Detection Settings.
  5. Carry out Noise Cancel.
  6. When ground balancing, press and hold the Quick‑Trak trigger, then start to sweep the coil at normal detecting height in a figure 8 motion.
    IMPORTANT: Make sure that you pass the coil over the ferrite almost immediately when you start the ground balancing procedure.
  7. Continue to sweep the coil over as much ground as possible, for 10–12 seconds, while passing the coil over the ferrite every sweep, as shown. NOTE: Once the audio tone remains quiet and constant when the coil is swept over the ferrite, ground balance is complete.
  8. Release the Quick-Trak trigger button and start detecting.

 

Thanks

Ross

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...