Jump to content
Nugget Shooter Forums
azdigger

Got a New to My 1994 Chevy G20 van

Recommended Posts

3 hours ago, azdigger said:

Hooked the wire up....NO JOY , still nothing...checked other wires best I could.....with volt / ohm meter.

Did you check the red wire before reconnecting it to see if it had 12 V going to it?

  • Like 1

Share this post


Link to post
Share on other sites

Yep , hook multi meter and read 12 v  , no other wire had power.

Share this post


Link to post
Share on other sites
18 minutes ago, azdigger said:

Yep , hook multi meter and read 12 v  , no other wire had power.

Okay. Now connect your red multimeter lead into that known 12v. With the black lead of your meter probe each wire for ground when the switches are operated. if you get the same results, it's probably a safe bet to replace the switch. 

  • Like 2

Share this post


Link to post
Share on other sites

Got to get a tool to remove door handle then I can get inside to see

Share this post


Link to post
Share on other sites

Well , after much testing , the window motor is bad , just got to replace it...never done this before

 

Share this post


Link to post
Share on other sites

Good luck man! They're not too terrible. You will more than likely skin your knuckles and cuss a bunch... but you'll get it. Then you will know that door backwards and forwards. :thumbsupanim

  • Like 2

Share this post


Link to post
Share on other sites

I agree with Dave, especially on the skinned knuckles, gets a bit tight but easily doable!

Have you found out what the issue is on the door locks not working?

  • Like 1

Share this post


Link to post
Share on other sites

Door locks needed WD-40

 

  • Like 2

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...