jarrod 12 Posted February 19, 2015 For me feed rate Share this post Link to post Share on other sites
MonsterGuppy 30 Posted February 19, 2015 (edited) Go slow then go slower,,, after that go slower still on a detector.. If we are talking sluces then moving as much materal as possible Edited February 19, 2015 by MonsterGuppy 2 Share this post Link to post Share on other sites
Hoser John 1,210 Posted February 19, 2015 What step of recovery you talkn'? John 1 Share this post Link to post Share on other sites
klunker 123 Posted February 19, 2015 Eegads! There are dozens of variables and adjustments regarding recovery. But I suppose the #1 key factor is putting gold into you recovery equipment (or under if your talking about detecting). Keep in mind that sometimes 80% recovery can be more profitable than 100% recovery especially in a commercial type opperation. 1 Share this post Link to post Share on other sites
jarrod 12 Posted March 8, 2015 yep finding it is where it all starts. I yet to try any detecting but looks fun!! but with a high banker and a table feed rate seems to be a big factor as all the other adjustments like water flow angle, classifying and better ground Share this post Link to post Share on other sites
GeoJack 576 Posted December 14, 2015 (edited) Classifying for me is #1 but I think it would depend on the size you are willing to put in the work to get it. >100 mesh is my bottom threshold. Feed rate is downstream from classifying. Gold Cube catches the fine stuff if classified. You'll blow out the small stuff if you don't. Edited December 14, 2015 by GeoJack Share this post Link to post Share on other sites
