Jump to content
Nugget Shooter Forums

HUNTING, FISHING, GUNS, and SUCH

As the title says this forum is for members to share stuff about Hunting, fishing, guns, etc.

483 topics in this forum

    • 4 replies
    • 807 views
  1. KNIFE vs GUN

    • 2 replies
    • 365 views
    • 7 replies
    • 421 views
  2. A WRONG GONE RIGHT!

    • 0 replies
    • 380 views
    • 4 replies
    • 587 views
  3. Scored

    • 2 replies
    • 424 views
  4. Texas whitetail

    • 10 replies
    • 682 views
  5. SHOOT YEA!

    • 3 replies
    • 462 views
  6. SHOOTING NATIONAL ANTHEM

    • 5 replies
    • 606 views
  7. FIND THE SNIPER

    • 6 replies
    • 493 views
  8. HERO OR VICTIM

    • 3 replies
    • 400 views
  9. It's here

    • 4 replies
    • 525 views
    • 5 replies
    • 436 views
  10. 6mm BR

    • 1 reply
    • 516 views
    • 0 replies
    • 553 views
  11. GOOD ADVICE!

    • 6 replies
    • 543 views
  12. Gooph Ball Deer

    • 3 replies
    • 607 views
    • 8 replies
    • 432 views
  13. Need a Coach Gun?

    • 7 replies
    • 496 views
  14. First Hog Hunt Story

    • 0 replies
    • 269 views
    • 2 replies
    • 488 views
    • 6 replies
    • 524 views
  15. Bought A 357

    • 21 replies
    • 860 views
    • 5 replies
    • 766 views
  16. Bear Poo

    • 8 replies
    • 413 views
  • Member Statistics

    8,607
    Total Members
    261
    Most Online
    ndg
    Newest Member
    ndg
    Joined
  • Who's Online   2 Members, 0 Anonymous, 14 Guests (See full list)

  • Posts

    • A rock with hot pink survey paint sprayed on it.
    • I used super glue to hold it together, then I ended up using Gorilla Glue (which is what I had on hand)  I  built up a complete cast around the outside from the holes on the coil ears to an inch down the shaft and was able to spread it on the inside as well.  I ground down the inside enough to slide the coil connector through.  It seems to be rock hard solid.  I installed the new lower shaft I bought but not before building up a cast around the outside like I did on my broken shaft for added strength.  I think it will be fine for a spare.  Appreciate all the helpful ideas that I can fall back on if my attempt doesn't hold. Doug  
    • Well Morlock you know ones that start fires.  
    • Reinforcing with fiberglass drywall tape works wonders   , and adding microspheres is great at thickening runny epoxies that need a long set time.
    • There are epoxies that adhere to plastic quite well- just look for it on the label. Always, but always, I cross hatch the area to be glued with a razor knife, then coarse sandpaper, and then acetone or non lubricant ether(starting fluid). I have even used brake cleaner in a pinch.
  • Today's Birthdays

    1. ColinT
      ColinT
      (74 years old)
    2. Kaimi
      Kaimi
      (73 years old)
×
×
  • Create New...